Hi Tapio,
CSS seemed to work for me the last time I tried. Is the result correct? And only the Feed Rate Display wrong.
What exactly are the steps
you are performing? What G Code are you using? And exactly what happens?
Regards TK
| Group: DynoMotion |
Message: 7508 |
From: tapiolarikka |
Date: 5/22/2013 |
| Subject: Re: feed/rev & constant surface speed? |
Hi Tom!
I turned some parts today and looks that the chip thickness stays constant so the CSS must be working correctly and the error is on the
feed rate display.
Rgds,
Tapio
--- In DynoMotion@yahoogroups.com, Tom Kerekes <tk@...> wrote:
>
> Hi Tapio,
>
> CSS seemed to work for me the last time I tried. Is the result correct? And only the Feed Rate Display wrong.
>
> What exactly are the steps you are performing? What G Code are you using? And exactly what happens?
>
> Regards
> TKÂ
>
>
>
> ________________________________
> From: tapiolarikka <tapio.larikka@...>
> To: DynoMotion@yahoogroups.com
> Sent: Tuesday, May 21, 2013 1:21 PM
> Subject: [DynoMotion] feed/rev & constant surface speed?
>
>
>
> Â
> Hi Tom!
>
> Should the feed/rev work with constant surface speed in Mach lathe mode?
>
> the feed/rev DRO shows increasing value as diameter gets bigger and revs go down.
>
> Rgds,
>
> Tapio
> |
|
| |
